Armaglass Connector L is used to mechanically connect our ARMAGLASS networks to various supports (brick walls, stone walls, concrete, wood). It is an extremely durable connector, even when applied on alkaline supports, with high salt loads or when exposed to severe exposure environments. It is extremely easy to handle, light and easy to apply, which allows for rapid intervention and low installation costs. The improved adhesion allows optimal adhesions with resinous grouting matrices and with all the materials typical of ancient and modern masonry (brick, stone, mortar, concrete). Armaglass Connector L is part of the RINFOR SYSTEM 5 CRM reinforced plastering system, certified according to European evaluation EAD 340392-00-0104.
Mechanical collaboration and connection of ARMAGLASS networks with supports. Reinforced plastering (CRM) interventions, even with high thickness, both on one side and on both sides of the masonry. Reinforcement of masonry arches and vaults. Reinforcement interventions on concrete structures. Particularly suitable for ancient walls of historical and cultural interest. Restoration and reinforcement interventions on buildings exposed to marine aerosol and offshore structures. Restoration and reinforcement interventions of water pipes, tanks, purifiers, piezometric towers, industrial water treatment tanks and in all structures that may be affected by the presence of aggressive soluble salts (chlorides, sulphates, nitrates, phosphates).
Drill the supports and then eliminate the dust with forced suction or a blast of compressed air, making sure that the support is free of loose and loose parts. Remove any salt efflorescence by brushing or sandblasting.
Proceed to make holes in the support of suitable diameter, inclination and depth, according to the design indications. Blow the inside of the hole with compressed air and then vacuum with an effective vacuum cleaner to free the hole from debris and dust. For grouting the connector with polyester resins such as Syntech Profix, act on a dry support, completely filling the hole with resin, inserting the nozzle of the cartridge deeply or using small conveyor tubes of suitable diameter. For grouting with mortars or slurries (Grout Cable, Grout Micro-J, Grout 2, Anchorsana Fix, Sanafluens, mortars from the Repar line), act on a damp surface by pre-washing with water; wait a few minutes, check that there is no water in the hole, fill the hole with mortar or grout, then insert the connector.
Product to be purchased as needed.
